Bronco Forum - Full Size Ford Bronco Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
10,188 Posts
Discussion Starter · #1 ·
I just need the spindle shaft that bolts to the dust shield.. I'm trying to change the rotors and the wheel bearing is siezed to it and I can't get it off, so I guess I just need to buy another spindle..

Has to be from the "top hat" style hubs. Manual locking hubs 87-88
 

· Registered
Joined
·
10,188 Posts
Discussion Starter · #6 ·
the 87-88 spindles are 1/2 the size of the other kind..

My wife didn't want to wait for me to get one since it was her DD.. (plus due to other reasons she hasn't been able to drive it for almost a month now)

I ended up just pulling off the spindle on that size and changing it with a spindle/rotor/hub assembly from a 91.. Only drawback is that the 91's front end was with auto hubs.. :( So now the drivers side is an auto hub setup from a 91 and an 87 manual setup on the pass side..

As soon as the brakes need to be done again I'll change the pass side over to the 91 setup and then switch it all over to manual hubs.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top