Bronco Forum - Full Size Ford Bronco Forum banner

1 - 6 of 6 Posts

Premium 4 Lyfe - Way Back Staff
'95 XLT: 5.8, MAF, E4OD, 4.56's, 6" on 33's
Joined
36,851 Posts
I can't come and get it... but if you would be willing to cut the trim and ship it, I'd be gratefull. :thumbup
 

Premium 4 Lyfe - Way Back Staff
'95 XLT: 5.8, MAF, E4OD, 4.56's, 6" on 33's
Joined
36,851 Posts
No no... I think you misunderstand me.
I'm not looking for the interior trim.

I'm asking if you can cut the trim (that bolts to the Bronco body) off the top for me.
I'm looking to make a custom soft-top and need the trim of the top to connect my soft-top to the bed rail.

Maybe using a disk cutter to trim about 1 inch up from the trim or "bottom edge".
Then cut in in a few strategic places so it would fit in a box and send it off to me.
I'd happily pay for shipping, and anything I can do to re-imburse you for your time.
I'm don't have extra cash right now (laid off and need to rebuild my motor)... but if your willing to do this for me, I'll start saving.

I know it's allot to ask... and you don't have to, no hard feelings.
If you will... you can get this prototype one step closer to reality.
If I can get the prototype built... I may be looking into building a few for sale to FSB members if it can be cost effective.

This is the concept...
 

Premium 4 Lyfe - Way Back Staff
'95 XLT: 5.8, MAF, E4OD, 4.56's, 6" on 33's
Joined
36,851 Posts
Can't hurt to try and if you cut them up higher than I need... no big deal.
If you can let me know and I'll tell you where I'd like them chopped lengthwise.
Thanks for trying to help out man. Greatly appreciated. :rockon
 
1 - 6 of 6 Posts
Top