Bronco Forum - Full Size Ford Bronco Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
686 Posts
Discussion Starter · #1 ·
Hey everyone, i hate having to post topic for easy help but i just couldn't find the information i was looking for on this subject, my problem is I've cracked 2 sets of exhuast manifolds and i'm going to get me some headers instead. i was looking at used stock mustang header off a 89 5.0 and was wondering about fitment onto my 92 bronco 5.0 with 6in suspension lift. I'm pretty sure they'll bolt on but what other mod will be needed if any?

I know i'll need
gasket
new studs
bolts
new coating
and a new y pipe
b
ut will they bolt on in the first place and not be a heade ache to run some exhuast off off? :shrug

TIA
Frank
 

·
Registered
Joined
·
686 Posts
Discussion Starter · #3 ·
yeah i know they aren't the best but for 11 bucks i think it's good enough to hold me untill i buy my 351 and start me build, then long tubed headers will be added, and yes i know about fitment problems with long tubes but i've seen some guys going with some that fit in nicely. thanks for the anwser though, I'll have my exhuast buddy make me a y-pipe he works at an exhuast place and did all my exhuast i got now new y pipe 2.5 single flow 40 behide rear tire, but my manifold is leaking again and i think it's becuase i didn't retighten and it warped becuase they're no cracks and i couldn't retighten it enough for it to go away no leaks anywhere else but around the pass manifold
 

·
Registered
Joined
·
686 Posts
Discussion Starter · #6 ·
thanks! hey another question before i go out to the junk yard (the headers for 11 bucks backed out) what should i expect to be paying for some headers from a mustang? 10 bucks each or something of that sort?
 
1 - 3 of 3 Posts
Top