Bronco Forum - Full Size Ford Bronco Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter #1
I ordered a Yukon ring pinion set to change gear ratio to 4 56
To my surprise I found the label on the box that arrived says made in CHINA
sorry Yukon but these are going back
 

·
Registered
Joined
·
99 Posts
Discussion Starter #3
Thank you. I just order from them. More than happy to pay a little more for piece of mind and support the USA
the fact is almost everything I have got made in China is garbage and a waste of time.
What really gets under my skin is the fact the vendor hides the origin of the product. Why? They know it’s not going to help sales. I might be more open to believing the part is of quality if they did not hide that it is from china
Go on their website and you will find they boast about quality and performance but no where can you find the name china
Buy USA made when possible
 

·
Registered
Joined
·
270 Posts
I agree.

What i find odd is on occasion i find something made in the US but they don't push that point.
 

·
Registered
Joined
·
270 Posts
They're probably made by US Gear or Dana
 

·
Premium Member
1979 Bronco Ranger XLT, 400m engine, C6 trans, D44 front with Dick Cepek manual locking hubs
Joined
·
557 Posts
good to know, as I may need to move front axle ratio to 4:10, then no Yukon
 

·
Registered
2-78 bronco,s-I is a ranger xlt and one is a custom-It has original 4 speed and I put a 390 in it
Joined
·
46 Posts
I ordered a Yukon ring pinion set to change gear ratio to 4 56
To my surprise I found the label on the box that arrived says made in CHINA
sorry Yukon but these are going back
Thanks Gondal, I didn,t know that. I won,t be buying anymore Yukon. I,ll start reading what is says on the box from now on.
 
1 - 9 of 9 Posts
Top